Aaeon MB-562 Manual page 69

Ô Ô Ô Ô Ô
These drivers are designed to work with Microsoft Windows Version
3.1. You may install these drivers either through Windows or in DOS.
1. Install Windows as you normally would for a VGA display. Run
Windows to make sure that it is working correctly.
2. Place the Win3.1 Display Driver in drive A. In Windows Program
Manager, choose File from the Options Menu. Then from the
pull-down menu, choose Run. At the Command Line prompt, type
A:\WINSETUP. Press the <ENTER> key or click OK to begin the
installation.
At this point the setup program locates the directory where Windows
is installed. For proper operation, the drivers must be installed in the
Windows subdirectory.
3. Press <ENTER> to complete the installation. Once completed, the
Display Driver Control Panel appears on the screen. This Control
Panel allows you to select and load the installed drivers.
Another method of installing these drivers is through the File Manag-
er. Click on Drive A:, and then double-click on WINSETUP.EXE to
begin installation.
Changing Display Drivers from Windows
To change display drivers from Windows, select the Windows Setup
icon from the Main window. You will be shown the current setup
configuration. Select Change System Settings from the Options menu.
Click on the arrow at the end of the Display line. You will be shown a
list of display drivers. Click on the driver you want to select it. Then
click on the OK button. Follow the directions to complete the setup.
Chapter 5 Flat Panel/ CRT Controller 61