Table of Contents
Advertisement
4
Smoke gas connecting piece top outlet
This wood stove has been prepared for a rear outlet by the
manufacturer. Lift the cover plate off the top plate and fit the
smoke gas connecting piece, the seal, and the fittings from
the service package (see page 3). At the same time, screw
down the ball stopper crosswise to prevent damage to the
smoke deflector plate when sweeping the chimney.
Ball stopper
Smoke gas
connecting
piece
Connection between top flue outlet and
steel chimney
Your Scan dealer, or local chimney sweep, can advise
you on choosing a make and type of steel chimney. This
ensures that the chimney will match your wood stove. As a
general rule, the length of the flue should not be less than
3.5 m measured from the top of the wood stove. Choosing
the wrong length or diameter of steel chimney could impair
functionality.
Always observe the chimney vendor's instructions preci-
sely.
Assembly with 90° knee pipe
You can also connect your wood stove using a 90° knee pipe
at the top outlet.
The cleaning flap on the knee pipe should be located in the
vertical section to allow cleaning of the horizontal section
through it
Requirements for flue
The flue must be labelled T400 and G for soot testing.
A S S E M B LY
Fresh air supply
In a well-insulated house, the air used up by the burning
process has to be replaced. This particularly applies to
houses with mechanical ventilation. There are different ways
of making sure that an air exchange takes place. The most
important thing is to ensure that there is a supply of air to
the room where the wood stove is located. The external wall
valve must be located as close to the wood stove as possi-
ble, and you must be able to close it when you are not using
the wood stove.
Fresh air connecting piece with valve
Assembling the fresh air connecting piece
and valve
If you ordered a fresh air connecting piece, please mount it
as shown below.
Hide quick links:
Advertisement
Table of Contents
