Connection Between Stove And Steel Chimney; Requirements For Chimney; Connection With 90° Elbow Pipe; Revolving Base And 90º Elbow Pipe - SCAN 50 Assembly Instructions And User's Manual

Connection between stove and steel chimney

Your Scan dealer, or local chimney sweep, can advise you on choosing
a make and type of steel chimney. This ensures that the chimney will
match your wood-burning stove. As a general rule, the length of the
flue should not be less than 3,5 m measured from the top of the
wood-burning stove.
If you decide on a wood-burning stove with a revolving base, perfect
working of your stove will depend to a great extent on having the
stove installed by a properly trained fitter. For instructions on fitting
a steel chimney with a revolving base, see pages 10 and 11.
Choosing the wrong length or diameter of steel chimney could
impair functionality.
Always observe the chimney vendor's instructions precisely.

Requirements for chimney

The chimney must be labelled T400 and G for soot testing.
Connection with 90° elbow pipe
If you intend to use an elbow pipe with the Scan 50-serie, we
recommend the use of a curved elbow pipe to improve the draft.
The cleansing lid on the elbow pipe must be located in the verti-
cal section of the pipe to allow cleaning of the horizontal section
through the access cover.
Revolving base and 90º elbow pipe
Best-possible working of your wood-burning stove with revolving
base, will depend to a great extent on having the stove carefully
installed by a properly trained fitter. For instructions on fitting an
elbow pipe for the revolving base, see pages 10 and 11.
A S S E M B LY

Flue collar top outlet

Your wood-burning stove has been prepared for a top outlet by the
manufacturer. Remove the cover plate from the top plate, and fit
the flue collar, the enclosed seal, and the fittings from the service
package. At the same time, fix the safety fitting crosswise to prevent
damage to the smoke deflector plate when sweeping the chimney.
Cover plate
Flue collar
Safety fitting
5