Table of Contents
Advertisement
Chapter 5 VGA Setup
5.1 Introduction
The PCM-4141 has an on-board VGA interface. The specifications and
features are described as follows:
5.1.1 Chipset
The PCM-4141 uses a Atlas STPC for its VGA controller, which supports
conventional analog CRT monitors. In addition, it also supports inter-
laced and non-interlaced analog monitors (color and monochrome VGA)
in high-resolution modes while maintaining complete IBM VGA compat-
ibility. Digital monitors (i.e. MDA, CGA, and EGA) are NOT supported.
Multiple frequency (multisync) monitors are handled as if they were ana-
log monitors.
5.1.2 Display memory
PCM-4141 has on board 64 memory, the VGA controller can drive CRT
displays or color panel displays with resolutions up to 1024 x 768 at 64 K
colors.
5.2 Installation of VGA driver
Complete the following steps to install the VGA driver. Follow those pro-
cedures in the flow chart that apply to the operating system which you are
using within your PCM-4141.
Important:The following windows illustrations are examples only. You
must follow the flow chart instructions and pay attention to the instruc-
tions which then appear on your screen.
Note 1:
Note 2:
PCM-4141 User Manual
The CD-ROM drive is designated as "U" through-
out this chapter.
<Enter> means pressing the "Enter" key on the
keyboard.
38
Advertisement
Table of Contents
