Assembly And Installation; Assemble The Stand - Power Fist 8699159 User Manual

V4.1
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List. Letter
references in parenthesis (A) refer to the included Identification Key. Dashed
numbers in parenthesis (Fig. 1-1) refer to a specific point in an illustration or image.

ASSEMBLE THE STAND

1. Insert the Pull Handle (#12) into the two mounting holes located in the
upper section of one Stand (#10). Then secure the Pull Handle to the
Stand, using two Pins (#11).
2. Attach one end of the Tool Plate (#128) to the upper section of one Stand
(#10), using two Bolts (#9), four Flat Washers (#8), and two Nuts (#6).
3. Attach the other end of the Tool Plate to the upper section of the remaining
Stand, using two Bolts (#9), four Flat Washers (#8), and two Nuts (#6).
4. Align the two mounting holes in the Wheel Bracket (#130) with the two
mounting holes located in the lower section of the Stand without the Pull Handle.
5. Secure the Wheel Bracket to the Stand, using two Bolts (#9), four Flat
Washers (#8), and two Nuts (#6).
Visit www.princessauto.com for more information
4-1/2 in. Metal Cutting Band Saw 8699159
Fig. 2
13