Table of Contents
Advertisement
Configuration
(Standalone)
Automatic Mode
Sound-Active
Mode
Sound Sensitivity
Manual Mode
Totem Mode
Intimidator Trio User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to power.
Never connect a product that is operating in any standalone mode (Automatic,
Sound-Active, or Manual) to a DMX string connected to a DMX controller.
Products in standalone mode may transmit DMX signals that could interfere with
the DMX signals from the controller.
To enable the Automatic mode, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Auto.
5.
Press <ENTER>.
To enable the Sound-Active mode, follow the instructions below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Sound.
5.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To set the sound sensitivity, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Sensitivity.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select 001-100, low to high.
7.
Press <ENTER>.
To test or control any function of the Intimidator Trio through the LCD display menu,
follow the instructions below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Manual.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select the function to test or control, from the options:
Pan, Tilt, P/T Speed, Color, Rotate, Zoom, Dimmer, and Shutter.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to change the value of the selected function, from 000–255.
9.
Press <ENTER>.
10. Repeat steps 6-9 until the functions are set as desired.
To set the Intimidator Trio to Totem mode, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to choose Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Totem Mode.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to choose OFF, DOWN, or UP.
7.
Press <ENTER>.
Page 19 of 27
Advertisement
Table of Contents
