Configuration (Standalone); Automatic Programs; Auto-Program Speed; Sound-Active Mode - Chauvet Freedom Stick User Manual

Configuration
(Standalone)
Automatic
Programs
Auto-Program
Speed
Sound-Active
Mode

Sound Sensitivity

Preset Color
Mode
Custom Color
Mixing
Freedom Stick User Manual Rev. 3
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the Freedom Stick in automatic mode, follow the instructions below:
1. Press <MENU> repeatedly until P-- shows on the display.
2. Press <ENTER>.
3. Use <UP> and <DOWN> to select an auto program (P 1–35).
4. Press <ENTER>.
For P 22–27:
5. Use <UP> or <DOWN> to select the first color (1--r, 1-rg, 1--g, 1-gb, 1--b, 1-rb,
1rgb, or 1OFF).
6. Press <ENTER>.
7. Use <UP> or <DOWN> to select the second color (2--r, 2-rg, 2--g, 2-gb, 2--b, 2-rb,
2rgb, or 2OFF).
8. Press <ENTER>.
For each program 22–27, color 1 and color 2 cannot be assigned the same color.
To change the auto-program speed on the Freedom Stick, do the following:
1. Press <MENU> repeatedly until S-- shows on the display.
2. Use <UP> and <DOWN> to increase or decrease the program speed (S 1–100).
3. Press <ENTER>. The product will return to the last selected mode.
To run the Freedom Stick in sound-active mode, do the following:
1. Press <MENU> repeatedly until Snd shows on the display.
2. Press <ENTER> twice to accept.
The product will only respond to low frequencies of music (bass and drums).
To change the sound sensitivity on the Freedom Stick, follow the instructions below:
1. Press <MENU> repeatedly until SenS shows on the display.
2. Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u 0–100).
3. Press <ENTER>. The product will return to the last selected mode.
To run the Freedom Stick in preset color mode, follow the instructions below:
1. Press <MENU> repeatedly until C-- shows on the display.
2. Press <ENTER>.
3. Use <UP> and <DOWN> to select a static color (C1–7).
4. Press <ENTER> twice to accept.
To custom mix a static color, follow the instructions below:
1. Press <MENU> repeatedly until U-- shows on the display.
2. Press <ENTER> and one of the following will show on the display:
·
r_ _ _ (red)
·
g_ _ _ (green)
·
b_ _ _ ( blue)
3. Press <ENTER> to cycle through the color settings.
4. When the desired color shows on the display, use <UP> or <DOWN> to increase or
decrease the color value.
5. Repeat steps 3 and 4 until the product outputs as desired.
Page 15 of 22