Table of Contents
Advertisement
Configuration
(Standalone)
Automatic
Programs
Auto Program
Speed
Sound-Active
Mode
Sound Sensitivity
Manual Dimming
Dimmer Speed
Temperature
COREpar UV USB User Manual Rev. 1
Set the product in one of the standalone modes to control without a DMX controller.
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To run the COREpar UV USB in automatic mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select an auto program (P 1–3).
4.
Press <ENTER>.
To change the auto-program speed on the COREpar UV USB, do the following:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the program speed (S 1–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To run the COREpar UV USB in sound-active mode, do the following:
1.
Press <MENU> repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select a sound-active program (Snd1 or Snd2).
4.
Press <ENTER>.
The product will only respond to low frequencies of music (bass and drums).
To change the sound sensitivity on the COREpar UV USB, follow the instructions below:
1.
Press <MENU> repeatedly until SenS shows on the display.
2.
Use <UP> and <DOWN> to increase or decrease the sound sensitivity (u 0–100).
3.
Press <ENTER>. The product will return to the last selected mode.
To manually control the output level, follow the instructions below:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> and d_ _ _ will show on the display.
3.
Use <UP> or <DOWN> to increase or decrease the dimmer value.
4.
Press <ENTER>.
To change the dimmer speed on the COREpar UV USB, do the following:
1.
Press <MENU> repeatedly until dIM shows on the display.
2.
Press <ENTER>.
3.
Use <UP> and <DOWN> to select:
·
dIM1 (fast)
·
dIM2 (medium)
·
dIM3 (slow)
or
·
OFF.
4.
Press <ENTER>.
To view the current temperature of the COREpar UV, follow the instructions below:
1.
Press <MENU> repeatedly until teMP shows on the display.
2.
Press <ENTER>.
Page 13 of 19
Advertisement
Table of Contents
