Configuration
(Standalone)
Static Color Mode
Automatic Mode
Custom Static
Color Mode
Page 12 of 18
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To enable the Static Color Mode, do the following:
1.
Press <MENU> repeatedly until C-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to choose a color (C1-C7).
4.
Press <ENTER>.
To enable the Automatic Mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to choose your auto program (P1-P4).
4.
Press <ENTER>.
You can adjust the speed of the automatic program as well.
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to adjust the duration of each step of the automatic program
from S001 (slow) to S100 (fast).
4.
Press <ENTER>.
To enable the Custom Static Color Mode:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER> to choose between colors (r--, g--, b--).
3.
Press <UP> or <DOWN> to choose the intensity of the color (r000-100).
4.
Repeat the steps to mix additional colors to create the color you need.
5.
Press <ENTER>.
SlimPAR™ 56 IRC IP User Manual (Rev. 2)