Table of Contents
Advertisement
Master/Slave
Mode
Intimidator Trio User Manual Rev. 1
The Master/Slave mode allows a single Intimidator Trio (the master) to control the
actions of one or more Intimidator Trio products (the slaves) without the need of a DMX
controller. The master will be set to operate in either Stand-Alone mode or with the
IRC-6, while the slaves will be set to operate in Slave mode. Once set and connected,
the slaves will operate in unison with the master.
Configure the products as indicated below.
Slaves:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Slave.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select Slave 1, Slave 2, Slave 3, or Slave 4.
·
Select Slave 1 for 100% synchronized actions.
·
Select Slave 2, Slave 3, or Slave 4 for a delayed show with all heads in the
same direction but with a delay creating a wave effect.
7.
Press <ENTER>.
8.
Connect the DMX input of the first slave product to the DMX output of the master.
9.
Connect the DMX input of the subsequent slaves to the DMX output of the previous
slave.
10. Finish setting and connecting all the slaves.
Master:
1.
Set the master to operate in either Stand-Alone mode or with the IRC-6.
2.
Make the master the first product in the DMX daisy chain.
When including Intimidator Wash Zoom products in Master/Slave configuration
with Intimidator Trio products, you must observe the following:
·
When the Intimidator Wash Zoom product is the master and the Intimidator
Trio is connected as a slave, the Intimidator Trio must be set to DMX mode
with a starting address of 001. DO NOT set the Intimidator Trio in Slave mode
when an Intimidator Wash Zoom product is the master.
·
The Intimidator Trio will not operate as the master to an Intimidator Wash
Zoom product connected as a slave.
·
Configure all the slaves before connecting the master to the DMX daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master.
·
Do not connect more than 31 slave products to the master.
Page 23 of 27
Advertisement
Table of Contents
