Using The Hafm Basic Interface; Launching The Hafm Basic Interface - HP StorageWorks Edge Switch 2/12 Installation Manual

4

Using the HAFM Basic interface

Use the HAFM Basic interface to configure the Edge Switch 2/12. Selectively perform the following
configuration tasks according to your installation requirements:
• Launching the HAFM Basic
• Setting the Edge Switch offline and
• Configuring Edge Switch
• Configuring BB
• Configuring Edge Switch
• Configuring date and
• Configuring Edge Switch
• Configuring network
• Configuring SNMP trap message
• Enabling or disabling the
• Configuring
• Connecting the Edge Switch to a
NOTE: This chapter describes the initial set up of the Edge Switch using the HAFM Basic interface.
For additional information on configuring advanced features using HAFM Basic interface, see the
HAFM Basic online help or the HAFM Basic user guide.

Launching the HAFM Basic interface

Use the following steps to launch the HAFM Basic interface:
NOTE: Internet access and a standard web browser is required. HP recommends Netscape
Navigator 4.6 or higher or Microsoft Internet Explorer 4.0 or higher.
1. Ensure that the browser-capable PC and the Ethernet LAN segment (with the Edge Switch
attached) are connected.
2. At the PC, launch the browser (Netscape Navigator or Internet Explorer).
interface, page 35
ports, page 37
credit, page 39
identification, page 40
time, page 41
parameters, page 42
information, page 45
recipients, page 46
CLI, page 48
zoning, page 54
fabric, page 54
online, page 37
Edge Switch 2/12 installation guide 35