HP StorageWorks Edge Switch 2/12 Installation Manual page 53

2. Ensure the preferred domain ID for the Edge Switch is unique and does not conflict with the ID of
another Edge Switch participating in the fabric. To change the domain ID, see
Edge Switch parameters" on page 42.
3. Ensure the R_A_TOV and E_D_TOV values for the Edge Switch are identical to the values for all
Edge Switches participating in the fabric. To change the values, see
parameters" on page 42.
4. Route a multimode or single-mode fiber-optic cable (depending on the type of SFP transceiver
installed) from a customer-specified E_Port of the switch to the switch.
5. Connect the switch-attached fiber-optic cable to the port SFP transceiver.
6. Select View to display the Switch tab.
7. Select Port Properties to display the Port Properties view, with 0 selected and port information
listed for port 0.
8. Select the port number of the port used to make this ISL connection.
9. Ensure the Operational State box displays Online and the Reason box displays N/A or is
blank.
If an ISL segmentation or other problem is indicated, see the Edge Switch service manual to
isolate the problem. If no problems are indicated, installation tasks are complete.
"Configuring
"Configuring Edge Switch
Edge Switch 2/12 installation guide 55