Configuring Port Binding - HP StorageWorks Edge Switch 2/12 Installation Manual

• Access Control List—As part of SANtegrity Authentication, use the IP Access Control List view to
configure a list of device IP addresses or a range of device IP addresses authorized to
communicate with the product.
• RADIUS—As part of SANtegrity Authentication, use the RADIUS Server view to configure up to
three remote authentication dial-in user service (RADIUS) servers. A RADIUS server stores and
authenticates passwords and CHAP secrets.
• Port Binding—Use the Port Binding view to bind an attached device WWN to a product Fibre
Channel port.
For instructions about configuring Security, see the HAFM Basic user guide.

Configuring port binding

Perform this procedure to configure Fibre Channel port binding by WWN.
1. Click Security > Port Binding.
The Port Binding view is displayed
Figure 27 Port Binding view
2. Select or clear the Port Binding check box to enable or disable port binding for a specified port.
Default is disabled.
3. Identify the WWN to which the port is bound using one of the following methods:
• Enter the WWN to which the port is to bind in the Bound WWN column.
(Figure 27).
Edge Switch 2/12 installation guide 53