Table of Contents
Advertisement
test
test
Tests the system.
Synopsis
test
Description
Performs a test on the entire system, excepting tape drives.
When the tests are successfully completed, the message ''tests
done'' is displayed. If any of the tests fail, a failure message is
displayed.
All tests run concurrently for a minimum of 30 seconds. Tests
complete when all component tests have completed at least one
pass. Test passes are repeated for any component that completes
its test before other components.
The run time of a test is proportional to the amount of memory
to be tested and the number of disk drives to be tested. Running
test
approximately 10 minutes to complete.
Examples
In the following example, the system, excepting tape drives, is
tested, and the tests complete successfully.
>>> test
tape drives, if any, will not be tested
tests done
>>>
3–24 Console Commands
on a system with fully configured 512-MB memory takes
Advertisement
Table of Contents
