Perform Post-Upgrade Tasks; Adding Third-Party Devices - DEC 4000 600 series Owner's Manual

Perform After Digital Services installs the options, you may want to do
Post-Upgrade one or more of the following tasks:
Tasks
•
•
•
Adding You can connect third-party SCSI, or licensed DSSI devices to
Third-Party the system by extending one of the system's mass storage buses.
Devices (See Terminating and Extending a Bus , later in this chapter.)
If you wish to mount third-party devices inside your system unit,
you will need to order and install special bracketry. Contact your
Digital sales representative or consult the Systems and Options
Catalog for the list of parts.
Planning a Change to Your Configuration
Set parameters for DSSI devices
For information about how to do this, refer to Setting and
Examining Parameters for DSSI Devices, later in this
chapter.
Change drive ID numbers
For information about how to do this, refer to Changing
Drive ID Numbers, covered earlier in this chapter.
Connect your system to a network
For information about connecting your system to the
network, refer to the instructions in the Network Installation
Guide that ships with the Ethernet.
System Configuration 6–17