Inserting A Compact Disc; Removing A Compact Disc; Rrd42 Light - DEC 4000 600 series Owner's Manual

Operating the RRD42 Compact Disc Drive
Inserting a To insert a compact disc into the RRD42 (Figure 5–5):
Compact Disc
1. Gather both the compact disc caddy and the disc you wish to
2. If there is a protective film on the center of the caddy lid,
3. Open the caddy by pressing the tabs on both sides of the
4. Set the disc, printed side up, into the caddy as shown
5. Press firmly on both corners to close the caddy lid.
6. Insert the disc caddy into the drive
7. When the busy light goes off, the compact disc drive is
Removing a To remove a compact disc (Figure 5–5):
Compact Disc
1. Press the eject button
2. Remove the caddy from the drive

RRD42 Light

The RRD42 busy light comes on when the system is reading data
from the compact disc.
5–14 Operating Mass Storage Devices
insert.
remove the film .
caddy at the end opposite the shutter
gently into the drive as far as it will go. The caddy should be
completely inside the drive when properly inserted.
The busy light comes on when the caddy has been inserted
correctly.
ready to use. To operate the compact disc drive, follow the
instructions provided with your system software.
The caddy will automatically eject part way.
.
. Push the caddy
.
.
.