Advertisement
IMPORTANT
Valve Adjustment
,
The surfaceburnersmay be dJfficu)t t o light dueto air in
the gas line underthe followingconditions:a) when first
The Lo setting should producea stable flame when turning
installed,b) if disconnectedfrom the main gas supply,
the knobfrom Hito Lo.The flameshould be1/8 inchor lower
or c) if range hasn't been used for several days. To
and must be stable on all ports on Lo setting.
remove air in the gas line, hold a lighted match next to
the burner head and turn the control knob on.
To adjust: Operate burner on Hi for about 5 minutes to
preheat burner cap.
1
When the control knob is turned ON, gas will flow into the
Turn knob back to
I
burner.The solidstate igniterwill clickuntilthe gasis ignited.
Lo; remove knob,
(Note" All burner igniters will spark regardless of which
and insert a small
burner is being operated.)
screwdriver into the
A properly adjusted burnerwith clean ports will light within
center of the valve
a few seconds.The cone-shapedflame willbe clear bluein
stem. Adjust flame
color with a clearly defined inner cone. There should be no
size
by
turning
trace of yellowin the flame, ifthe burner flame is yellow,lifts
adjustmentscrew in
offthe ports,or isnoisy,the air/gasmixture may beincorrect,
eitherdirectionwhile
Therefore,contacta servicetechnicianto make the needed
holding the valve
adjustment,
stem securely.
The infinitesurface controlsprovideflexibilityin heatsetting
Flame must be of sufficient size to be stable on all burner
selection. (See page 7.)
ports.If flameadjustmentis needed,adjust ONLYonthe Lo
Operate
in the Event of
a Power
}
setting.Never adjust flame size on a higher setting.
IR..FadureOW
to
I
servicerN°te:
Allonly.gas
adjustments should be done by a qualified
In case of prolonged power failure, you can manually light
the surface burner by holding a lighted match near the
burner ports and slowly turning the control knob
counterclockwise(after depressing)to the Lite setting.
Caution: Whenlightingthe surface burner;be sure ai! I
of the controls arein theOFF posEion; StrikethematchI
firstandholdit inpositionbeforeturningtheknobtOthe
Utepostion,,
,,
Note: Becauseyour overhead hoodfan is electric it will not
work duringa powerfailureso smokeandcondensationcan
gather.
Advertisement
