D Gps Message Programming - Icom IC-E91 Instruction Manual

D D GPS message programming
q Enter "GPS" in message/position set mode.
➪
MENU screen MESSAGE/POSITION
(Push [MENU/LOCK]) (Rotate [DIAL]
• GPS MESSAGE screen is displayed.
w Push [≈ ≈ ](6) to select the message edit condition.
• The 1st digit of the message blinks.
GPS MESSAGE GPS MESSAGE
DATA: DATA:
r
†
:SET :SET
:SEL :SEL
:CUR :CUR
e Rotate [DIAL]
†
to select the desired character or symbol.
• Push [A/a](3) to change the character group from "AB" (alpha-
betical characters; capital letters), "ab" (alphabetical characters;
lower case letters), "12" (numbers) and " !" " (symbols) in se-
quence.
rPush [≈ ≈ ](6) to select 2nd digit, then rotate [DIAL]
the desired character or code.
• Push [≈ ≈ ](6) to move the cursor right; push [Ω Ω ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
DV MODE OPERATION (Optional UT-121 is required)
➪
GPS
† †
, then push [ï](5) .)
AB AB
CLR:CLR CLR:CLR
A/a:CHAR A/a:CHAR
†
to select
t Repeat the steps r and t to enter the desired message.
• Up to 20-character messages can be set.
GPS MESSAGE GPS MESSAGE
DATA: DATA:
r
Hello!† Hello!
:SET :SET
:SEL :SEL
:CUR :CUR
y Push [ï](5) to store the message.
u Push [MENU/LOCK] to return to frequency indication.
[DIAL] ↔ [∫ ∫ ](2)/[√ √ ](8)
†
AB
CLR:CLR CLR:CLR
A/a:CHAR A/a:CHAR
[ï](5) ↔ [≈ ≈ ](6)
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
59