I Duplex Operation - Icom IC-E91 Instruction Manual

6
REPEATER AND DUPLEX OPERATIONS

I Duplex operation

Although [DIAL] and [ï](5) are used for description in this
section, [∫ ∫ ](2)/[√ √ ](8) and [≈ ≈ ](6) are available instead of
[DIAL] and [ï](5).
D Setting offset frequency
q Enter "OFFSET FREQ" in DUP/TONE... set mode. (p. 97)
➪
MENU screen
(Push [MENU/LOCK]) (Rotate [DIAL]
w Rotate [DIAL]
†
to set offset frequency.
• 1 MHz and 10 MHz tuning steps are available by pushing and
holding [MHz](VFO) for 1 sec.: push [MHz](VFO) to cancel it.
e Push [ï](5)
(or [Ω Ω ](4))
and push [MENU/LOCK] to return to frequency indication.
No offset frequency
OFFSET FREQ OFFSET FREQ
0.000.00 0.000.00
32
➪
DUP/TONE... OFFSET FREQ
†
, then push [ï](5)
to return to DUP/TONE... set mode,
5.0 MHz offset
OFFSET FREQ
5.000.00 5.000.00
D Setting duplex direction
➥ Push and hold [DUP](4) for 1 sec. to select "–DUP" or
"+DUP".
• "–DUP" or "+DUP" indicates the transmit frequency for minus
shift or plus shift, respectively.
• When offset frequency is 0.6 MHz.
†
.)
[DIAL] ↔ [∫ ∫ ](2)/[√ √ ](8)
†
[ï](5) ↔ [≈ ≈ ](6)