Table of Contents
Advertisement
SECTION 9
SUPPLEMENT 22
PA-32R-301, SARATOGA II HP
SECTION 4- NORMAL PROCEDURES (continued)
•
To perform the preflight checklist and self test:
•
After successful self test, press the mode control until ANT is displayed and
input a predetermined frequency to select a station in the immediate area.
Adjust the volume control as necessary to provide a comfortable listening
level.
•
Press the ID button and observe that the station identitication code becomes
louder (if the station is voice-identitied, it is not necessary to press the ID
button).
•
Press the ID button again to cancel the IDENT function and press the mode
control until ADF is displayed.
•
Observe the IND-650A Indicator and note that the bearing pointer
indicates the relative bearing to the station.
•
Push the TEST button while observing the indicator bearing pointer. The
bearing pointer will rotate 90° and stop.
•
Push the TEST button again (to turn off test function). The bearing
pointer returns to tl1e original relative bearing position.
•
Switch to BFO mode, if appropriate, and verify a tone is present. Select tl1e
appropriate operating mode when all checks have been completed.
SECTION 5- PERFORMANCE
No change.
SECTION 6 - WEIGHT AND BALANCE
Factory installed optional equipment is included in tl1e licensed weight and
bala11ce data in Section 6 of the Pilot's Operating Ha11dbook a11d Airplane Flight
Ma1mal.
REPORT: VB-1669
9-170,
4 of 10
ISSUED: .JUNE 30, 1997
REVISED: .JULY 11, 2005
Advertisement
Table of Contents
