Table of Contents
Advertisement
L L L L
WARNING:
Risk of injury - Perform the adjustment of the seat angle with 2
persons or place something between the seat frame and lower frame.
L L L L
WARNING:
Risk of injury - Keep fingers, buckles and clothes away from the
attachment points of the seat frame.
3.3.2 Adjusting the seat depth
L L L L
WARNING:
Risk of injury - Never change the seat depth when the user is sitting in
the wheelchair.
The Vermeiren Navix is adjustable in different seat depths over a range of 380 mm to 500
mm.
1. One person shall hold the seat frame upwards
or place something between the seat frame
and lower frame to avoid that the seat frame
can fall down.
2. Loosen screw Ⓑ from the front plate a little bit
so it will be possible to rotate the bar Ⓐ
around these attachment point.
3. Remove the screw Ⓒ from the connection bar
for seat inclination Ⓐ.
4. Place the seat angle in the desired position by
position the connection bar Ⓐ in the right
position (refer to table 6).
5. Retighten the screws Ⓑ, Ⓒ properly.
1. Remove the seat cushion with the velcro
straps.
2. Loosen the hexagon socket set screws Ⓒ
just under the seat frame.
3. Loosen the screw Ⓓ on the seat plate a
little bit.
4. Place the seat plate in the correct seat
depth by moving the square tubes Ⓐ and
Ⓑ over each other.
5. Retighten the screws Ⓒ, Ⓓ properly.
6. Replace the seat cushion with the Velcro
straps.
The seat depth dimension you can read on the
seat plate Ⓔ. The head of the screw Ⓓ shall
give the seat depth dimension.
Page 27
Navix
2012-10
Advertisement
Table of Contents
