Possible Adjustments - Vermeiren NAVIX Instruction Manual

3.3

Possible adjustments

L L L L
WARNING:
Risk of injury - Turn the electric wheelchair off before you perform any
adjustments.
L L L L
WARNING:
Risk of injury - Never perform any adjustments while you are driving.
L L L L
WARNING:
Risk of injury - Adjustments may only performed by your specialist
dealer.
L L L L
WARNING:
Risk of injury - Make sure all screws, handles are firmly secured
before driving with your electric wheelchair.
L L L L
CAUTION: Risk of clamping – Keep fingers, buckles and clothes away from the
attachment points or any moving parts.
3.3.1 Adjusting the seat height and angle
L L L L
WARNING:
Risk of injury - Never change the seat height or angle when the user is
sitting in the wheelchair.
The Vermeiren Navix is adjustable in 3 different seat heights by changing the position of the
front plates Ⓐ and the back plates Ⓑ of the seat frame upwards or downwards.
1. Remove the screw Ⓒ from the front plates Ⓐ of the seat frame.
2. Place the seat height in the desired position by mounting the connection bar for seat
inclination Ⓔ in the right hole of the front plates Ⓐ (refer to table 5).
3. Retighten the screw Ⓒ properly.
4. Remove the screws Ⓓ from the back plates Ⓑ of the seat frame on each side.
5. Place the seat height in the desired position by mounting plate Ⓕ of the lower frame
in the right hole of the back plates Ⓑ.
6. Retighten the screws Ⓓ properly.
The Vermeiren Navix is adjustable in 3 different seat angles by changing the position of the
connection lath for seat inclination Ⓐ.
Place the connection bar for seat inclination Ⓐ Ⓐ Ⓐ Ⓐ with
the holes positioned as shown on the figure.
Seat height
without seat
cushion
400 mm
450 mm
(Standard)
500 mm
Seat angle Position connection
5° (standard)
7,5°
10°
Page 26
2012-10
Position front
plate Ⓐ Ⓐ Ⓐ Ⓐ
and back
plate
Ⓑ Ⓑ Ⓑ Ⓑ
Hole 1
Hole 2
Hole 3
Table 5: Seat height
bar for seat
inclination Ⓐ Ⓐ Ⓐ Ⓐ
Hole 1
Hole 2
Hole 3
Table 6: Seat angle
Navix