Table of Contents
Advertisement
2.10 Seat cushions
2.11 Back rest cushions
L L L L
WARNING: Risk of injury – Check that all straps are secured with Velcro.
1. Remove the back rest cushion
frontside to the front, back rest cushion
back rest cushion
system with straps
2. Loosen the velcro closures
3. Pull the respective strap
can be varied and the desired support of the back can be set.
4. Replace the back rest cushion
2.12 Transfer in and out the electric wheelchair
L L L L
CAUTION:
In case you cannot perform the transfer in a safe manner, ask
someone to assist you.
L L L L
CAUTION:
Risk of injury – Do not use the joystick, footplates, armrests as
support.
L L L L
CAUTION:
Risk of tipping over of the wheelchair – Do not stand on the foot
plates.
The seat cushion
with the velcro strips
.
The back rest cushions
mounted with the velcro strips
velcro straps
The back can be adjusted in its flexibility, so the
back of the user is supported differently.
with the velcro
on the back side backwards. Now you can see the suspension
that can be adjusted independently.
of the respective straps
to the desired position, the tension of the individual belts
.
1. Park the electric wheelchair as close as possible to
the place where you want to transfer.
2. Check that the operator control is switched off.
Make sure that the wheelchair is NOT in freewheel
mode.
3. Fold the foot plates upwards to prevent standing on
them.
4. If the transfer is on the side of the wheelchair, fold
the armrest on that side away.
5. Transfer to / from the electric wheelchair.
Page 17
can be removed or mounted
on the seat frame plate
.
. Pull the back rest cushion
comes from the velcro straps
.
Navix
2012-10
can be removed or
on the backrest
on the
. Pull the
Advertisement
Table of Contents
