Ezgo 605586 Repair And Service Manual page 128

ELECTRICAL
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
ing indicates (a) a poor connection between the
probes and the battery terminals; (b) a faulty DVOM. A
voltage reading below 11 volts indicates poor battery
condition and the vehicle should be recharged before
proceeding with the test.
Due to the resistance of the wires involved within the harness,
voltage readings may be somewhat lower than battery voltage.
A reading of 1 volt below battery voltage is acceptable.
3. Check power wire
Firmly attach the black probe (-) to the battery post
with the black wire attached and the red probe (+) to
the green wire terminal at the fuse block. A reading of
battery voltage indicates that the power wire is in good
condition.
The power wire supplies power to the entire fuse block.
4. Check fuse
Place the red probe (+) to each wire terminal on the
fuse block. A reading of battery voltage indicates that
the fuse is in good condition. No reading indicates a
faulty fuse; replace with a good 15 amp fuse.
Page L-10
ACCESSORY WIRING
After determining that there is power to the fuse panel,
and the fuse is good, continue checking the circuit using
the procedures previously used to check the power sup-
ply, i.e. loose or rusted connections, bare wires, continu-
ity of the wiring from terminal to terminal, operating
condition of switch, etc.
Use the wiring diagram (Ref. Fig. 9 on Page L-11) to
check correct wiring and wire routing. If there is power at
the fuse end of the wire, there must also be power at the
other end of the wire at the switch or electrical acces-
sory, and eventually at the ground connection. Electricity
must flow from the fuse panel through the full length of
the circuit to the ground connection. Any interruption of
electrical flow must be corrected, whether by repairing or
replacing the wire, the switch or accessory
Repair and Service Manual