Fuel Lines & Filter - California Emission Requirement; Carb Installation - Ezgo 605586 Repair And Service Manual

FUEL SYSTEM
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
Fuel Pump
FUEL LINES & FILTER - CALIFORNIA
EMISSION REQUIREMENT
Tool List
Needle nose pliers....................................................... 1
Straight blade screwdriver ........................................... 1
Fuel is supplied to the fuel pump and carburetor through
flexible fuel hoses. An in-line filter is installed in the hose
between the fuel tank and the fuel pump (Ref. Fig. 9 on
Page H-8).
Read and understand the following text and warnings before
attempting installation
Page H-8
Fuel
Filter
Fig. 9 California Emission Requirement
Qty. Required
Repair and Service Manual
Part of
Frame

Carb Installation

1 Disconnect the negative ground from the battery
before starting the installation.
2 Remove the existing hoses and clamps from the
fuel tank to the fuel pump and from fuel pump to
the carburetor and discard.
Care should be taken while removing hoses
due to the presents of fuel remaining in the
lines.
3 Install fuel filter assembly insuring a smooth loop In
the supply lines, secure with tubing clamps (4) pro-
vided. (Ref. Fig. 9 on Page H-8)
4 Install the new fuel hose from the fuel pump to the
carburetor, secure with hose clamps provided.
(Ref. Fig. 9 on Page H-8)
Fuel
Tank