Table of Contents
Advertisement
Lifecycle 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE HOUSING
Tools Required: Phillips screwdriver
STEP 1
With a phillips screwdriver, remove the two exterior screws on the user right hand side handlebar neck shroud.
Once removed the user left handlebar neck shroud can be removed. Loosen and remove the inner neck shroud
screw and remove the user right side neck shroud.
STEP 2
To remove the LEFT PEDAL, small hole-side of HOUSING, place a 5/8 inch open-end wrench on the PEDAL BOLT
and turn the wrench clockwise. To remove the RIGHT PEDAL, sprocket side, place a 5/8 inch open-end wrench on
the PEDAL BOLT and turn the wrench counterclockwise.
STEP 3
With a phillips screwdriver, remove the screw on the user right side seat post shroud. Once removed, separate
the two neck shrouds.
STEP 4
With a Phillips screwdriver, remove the remaing 9 screws on the user right hand shroud. Swing the SPROCKET
side (right) CRANK ARM up to the 2 o'clock position and guide the HOUSING up and over the CRANK ARM.
STEP 5
Once the user right shroud is removed, remove the 3 inner screws holding on the left shroud. Swing the small-hole
side (left) CRANK ARM down to the 4 o'clock position and guide the worn HOUSING out and over the CRANK
ARM.
STEP 6
Reverse this procedure for reassembly.
20
Torque
6-10 in. lbs.
(Typical)
Torque
6-12 ft. lbs.
Hide quick links:
Advertisement
Table of Contents
