LifeFitness Lifecycle 9500HR Service Manual page 42

Lifecycle 9500HR Series Exercise Bikes
How To...REMOVE AND REPLACE THE DRIVE BELT
Tools Required: Two Standard screwdrivers, long-nose pliers, or E-ring tool
STEP 1
Remove the Housing. Refer to "How To...." in this section.
STEP 2
Remove the Alternator Belt. Refer to "How To...." in this section.
STEP 3
Loosen the hex bolt on the bracket assembly and slacken the belt.
STEP 4
Remove the three FLAT INNER E-RINGS and the BENT OUTER E-RING. Use either two screwdrivers, long-nose
pliers, or an E-Ring tool.
CAUTION! THE E-RINGS ARE UNDER LOAD. PLEASE REMOVE THEM SLOWLY AND CAREFULLY.
STEP 4
From the BELT side, use a center punch and a small hammer to tap out the SHAFT from the PULLEY BRACKET.
STEP 5
Pull the PULLEY forward and out of the bike frame and remove the BELT.
STEP 6
Reassembly is the reverse of removal.
Lifecycle 9500HR Series Exercise Bikes
4
Remove
E-Rings
Loosen
Hardware