Removing And Carrying The Outboard Motor; Removing The Outboard Motor; Carrying The Outboard Motor - TOHATSU MD 30B2 Owner's Manual

68

REMOVING AND CARRYING THE OUTBOARD MOTOR

ENOM00688-0

1. Removing the outboard motor

1. Stop the engine.
2. Disconnect the fuel connector, the
remote control cables, the battery
cords, bracket fixing bolts and nuts
etc.
3. Remove the outboard motor from the
hull and completely drain the water
from the gear case.
ENOW00064-0
CAUTION
Engine may be hot immediately after oper-
ating and could cause burns if touched.
Allow engine to cool down before attempt-
ing to carry the outboard.
ENOM00689-0

2. Carrying the outboard motor

Be sure to keep the engine vertical when-
ever you carry the outboard motor.
ENOW00617-0
 Close air vent screw of fuel tank before
carrying or storing outboard motor and
fuel tank, or fuel may leak, potentially
catching fire.
 Do not give a shock to an outboard
motor during transportation. It becomes
a cause of breakage.
ENOW00073-0
Please disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOM00690-0
EFTO, EPTO type
When carrying or putting the engine up for
storage, make sure the side with the elec-
tric motor of the Power Trim and Tilt is
down otherwise air will enter the pump
system for the Power Trim and Tilt opera-
tion.
ENOF00709-0
WARNING
WARNING
ENOF00075-0