Buffalo TeraStation TS5800D User Manual page 92

3
Click [List of LinkStations and TeraStations].
4
(1) Check the IP address of the LinkStation or TeraStation that you want to set as the backup location.
(2) Click [Add], enter the IP address of the target LinkStation or TeraStation, and click [Close].
If you meet the following conditions, then you don't have to confi gure the settings described above:
• The source and target TeraStations are on the same network.
• No backup password is set for the target TeraStation.
• No TeraStation from outside the subnet, or connected by a VPN, is used.
Note:
To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both
devices are confi gured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes of these are
signifi cantly diff erent, the backup job may not be properly performed. In such a case, select the default frame size
(1518 bytes).
Next, refer to "Confi guring a Backup Job".
91