Buffalo TeraStation TS5800D User Manual page 75

Disconnecting and Unregistering the TeraStation
To disconnect the TeraStation, disconnect the volume and remove the registration as shown below.
1
Click [Start] - [All Programs] - [BUFFALO] - [iSCSI Hard Disk Connection Tool] - [iSCSI Hard Disk Connection Tool]. The
iSCSI Hard Disk Connection Tool will launch.
2
Select the volume to disconnect from [Volume], then click [Remove].
Notes:
• When disconnecting the TeraStation, disconnect all connected volumes.
• To disconnect multiple volumes in a single operation, follow the procedure below.
1. Start the iSCSI Hard Disk Connection Tool.
2. Click [Setup] - [Remove the registered iSCSI Hard Disk].
3. Select the volume to be disconnected, then click [Remove].
This completes the disconnection of multiple volumes.
3
Click [Yes].
4
Select the TeraStation to be disconnected from [Target product], then click [Remove the registered iSCSI Hard Disk].
Note:
When connecting to the TeraStation from multiple computers, follow the above procedure to remove the
registration from each computer.
5
Disconnect the Ethernet cable of the TeraStation.
This completes the disconnection of the TeraStation.
Notes:
• If the TeraStation is disconnected from the network or the IP address is changed without removing the
registration, the registered information remains stored in the computer registry, and searches will take longer.
74