Replacing The Unit Connecting Line; How To Replace The Power Connection Cables In The Heating Hose Drum - WAGNER NESPRAY PLUS Operating Instructions Manual

GB
REPAIRS AT THE UNIT
12.7

REPLACING THE UNIT CONNECTING LINE

Switch the unit off
Before all repair work: Unplug the power
plug from the outlet.
1. Dismantle the carriage.
2. Unscrew the device socket for the heating hose drum
from the housing and disconnect.
3. Screw off and remove a housing half (with socket open-
ing).
4. Loosen the cable threaded joint (1).
5. Loosen the wires in the mains terminal.
6. Replace the unit connecting line.
(only an approved power cable with the designation H07-
RNF with a splash-proof plug may be used).
7. Mount the housing half carefully (do not squeeze any ca-
bles!)
8. Connect the socket for the heating hose. Connect the
green/yellow wire to the contact with the earthing sign.
Connect the other two wires to Contact 1 and 2.
1
56
(OFF).
2
12.8
HOW TO REPLACE THE POWER CONNECTION
CABLES IN THE HEATING HOSE DRUM
Switch the unit off.
Before all repair work: Unplug the power
plug from the outlet.
Work or repairs at the electrical equipment
may only be carried out by a skilled electri-
cian. No liability is assumed for incorrect in-
stallation.
1. Dismount the hose reel (1) by loosening the 2 screws (2)
on the carriage (3).
2. Lever the plastic cover (4) off with a screwdriver.
3. Release cable connexion (5).
Disconnect the power cable from the terminal strip (6).
4. Replace power cord (fix green-yellow conductor to PE-
marked terminal).
(Only use a licensed power cord with the marking H07-
RNF and with a splash water proof plug)
5. Mount plastic covers carefully.
6. Fix hose reel to the carriage again.
1
NESPRAY PLUS
3
2
6
4
5