Advanced; Virtual Server - D-Link DIR-860L User Manual

Section 3 - Configuration
This page will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name: Enter a name for the rule or select an application from the drop-down
menu. Select an application and click << to populate the fields.
IP Address: Enter the IP address of the computer on your local network that you
want to allow the incoming service to. If your computer is receiving an
IP address automatically from the router (DHCP), your computer will
be listed in the "Computer Name" drop-down menu.
Private Port/ Enter the port that you want to open next to Private Port and Public
Public Port: Port. The private and public ports are usually the same. The public
port is seen from the Internet side, and the private port is used by the
application on the computer within your local network.
Protocol: Select TCP, UDP, or Both.from the drop-down menu.
Schedule: The schedule of time when the Virtual Server Rule will be enabled. The
schedule may be set to Always, which will allow the particular service
to always be enabled. You can create your own times in the Tools >
Schedules section.
Inbound Filter: Select Allow.All (most common) or a created Inbound filter. You may
create your own inbound filters in the Advanced.>.Inbound.Filter
page.
Click Save.Settings to save the current configuration.
D-Link DIR-860L User Manual

Advanced

Virtual Server

71