Table of Contents
Advertisement
CONT:GPIO:DIRECTION 15
CONT:GPIO:DIR 16
Q43. How to read back and set up GPIO levels?
CONT:GPIO 3
CONT:GPIO?
Q44. How to read back serial number?
MEM:SERIAL?
MEMORY:SER?
Q45. How to modify machine ID (address)?
CONTROL:ADDR 23
CONT:ADDRESS 09
Q46. How to check password?
CONT:PASSWORD 12345
Q47. How to enter or leave the monitor mode? (GPIB & LAN not support )
CONT:MONITOR ON
CONTROL:MONI OFF
Q48. How to change channel?
CONT:CHANNEL 1
CONT:CH 1
CONTROL:CH 2
Q49. How to enter or leave lock status?
CONT:LOCK ON
CONTROL:LOCK OFF
Q50. How to enter or leave hotkey status?
CONT:HOTK ON
CONTROL:HOTKEY OFF
Q51. How to measure current?
==> set GPIO pin 1 ~ pin 4 as the outputs
and the pin 6 ~ pin 9 as the inputs
==> set GPIO pin 6 as the output and other
pins as the inputs
==> set GPIO pin 1 and pin 2 to output a
high level
==> if return a value of 96, it means the input
pin 7 and pin 8 are high and other input
pins are low
==> modify id to 23
==> modify id to 9
==> enter password to verify
==> enter the monitor mode
==> exit the monitor mode
==> change to channel 1
==> change to channel 1
==> change to channel 2
==> enter lock mode
==> exit lock mode
==> enter hotkey mode
==> exit hotkey mode
33
Advertisement
Table of Contents
