Motech LPS 505N User Manual page 37

[ state/bool]
:HOTKey
[ state/bool]
:LOCK
[ state/bool]
:MONItor
[ state/bool]
:DHCP
[ state/bool]
:IP
[?/ xxx.xxx.xxx.xxx]
:CHannel
[ n]
:ADDRess
[?/ n]
:DEFault
:PWD
:PASSword
[ string]
:LOCAL ON
:GPIO
[?/ level]
:DIRection n
GPIO Pin 9 Pin 8
Bit Bit 7 Bit 6
Value 128
MEASure
:CURRent[n]?
:VOLTage[n]?
:POWer[n]?
:RESistance[n]?
SOURce
Pin 7 Pin 6
Bit 5 Bit 4
64 32 16
enable/disable hotkey mode
enable/disable keypad and rotary lock
enable/disable monitor to send "status" & V/I
message(GPIB & LAN not support )
select DHCP command
enables/disables DHCP mode
select IP command
return IP address or set IP address
select channel
channel number n: 1 - 3
set up GPIB address for PPS3210
return or set GPIB address n: 1 - 31
resume factory preset(password protected)
enter password to verify
the string must be less than 15 characters
disable remote mode and back to local
mode
this command is valid when optional card
exists
read or set up level of GPIO pins, level: 0 -
255
set GPIO pins as input or output (0-input,
1-output), n: 0 – 255
Pin 5 Pin 4
GND Bit 3
X 8
measure subsystem for channel n: 1 - 3
Return the floating point value of the DC
output current in amps for channel n: 1 - 3.
Return the floating point value of the DC
output voltage in volts for channel n: 1 - 3.
Return DC output power in watts.
Return DC output impedance in ohms.
source subsystem
Pin 3 Pin 2 Pin 1
Bit 2 Bit1 Bit 0
4 2 1
29