Front I/O Assembly - HP ProDesk 600 G1 Tower Maintenance And Service Manual

Front I/O assembly

Description
Front I/O assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the three front I/O cables from the following system board connectors:
FRONT USB
●
MEDIA 3.0
●
FRONT AUD
●
5. Remove the Torx T15 screw that secures the assembly to the chassis (1).
6. Rotate the right side of the assembly outward (2).
7.
Pull the assembly away from the computer while threading the wires through the hole in the front
of the chassis.
To reinstall the assembly, reverse the removal procedure.
66 Chapter 5 Removal and replacement procedures: Tower (TWR)
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 39).
37).
Spare part number
732750-001
36).