HP ProDesk 600 G1 Tower Maintenance And Service Manual page 120

Hide thumbs Also See for ProDesk 600 G1 Tower:
Table of Contents

Advertisement

4.
Install four black and blue M3 isolation mounting guide screws (two on each side of the drive).
NOTE:
When replacing a drive, transfer the four M3 isolation mounting guide screws from the old drive
to the new one.
5.
Rotate the drive cage to its upright position.
6.
Align the guide screws on the drive with the J-slots on the sides of the drive bay. Press the drive up
into the drive bay then slide it forward until it locks in place.
7.
Connect the power cable and data cable to the back of the hard drive.
NOTE:
SATA connector labeled SATA0 on the system board. If it is a secondary drive, connect the data
cable to one of the light blue SATA connectors on the system board.
8.
Rotate the drive cage back down to its normal position.
CAUTION:
110
Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
M3 metric isolation mounting guide screws can be purchased from HP.
If the 2.5-inch hard drive is the primary drive, connect the data cable to the dark blue
Be careful not to pinch any cables or wires when rotating the drive cage down.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prodesk 600 g1 small form factor

Table of Contents