Installing A 3.5-Inch Device - HP ProDesk 600 G1 Tower Maintenance And Service Manual

Installing a 3.5-inch device

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
a bezel blank, remove the bezel blank. See
4. Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
on page 98
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5. Rotate the drive cage to its upright position.
102 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
(Access panel on page
(Front bezel on page
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the extra guide screws location.
(Preparation for disassembly on page
85).
86). If you are installing a drive in a bay covered by
Bezel blanks on page 89
84).
for more information.
Drives