Assembly Instructions - LifeGear 26470 Owner's Manual

ASSEMBLY INSTRUCTIONS

Tool:
1 3
64 64
1. Front and Rear Stabilizers Installation
Turn the Round Knob (47) in a counterclockwise direction until it can be pulled out. Pull out
the Round Knob (47) and then slide the Rear Main Frame (39) forth or back direction to the
suitable position. Lock the Rear Main Frame (39) in place by releasing the Round Knob (47)
and sliding the Rear Main Frame (39) forth or back slightly until the Round Knob (47)
"pops" down into the locked position. For added safety, tighten the Round Knob (47) in a
clockwise direction.
Position the Front Stabilizer (58) in front of the Front Main Frame (27) and align bolt holes.
Attach the Front Stabilizer (58) onto the front curve of the Front Main Frame (27) with two
M10x60 Carriage Bolts (35), two Ø22xØ10x1.5t Washers (13), and two M10 Cap Nuts (65).
Tighten cap nuts with the Multi Hex Tool provided.
Position the Rear Stabilizer (64) behind the Rear Main Frame (39) and align bolt holes.
Attach the Rear Stabilizer (64) onto the rear curve of the Rear Main Frame (39) with two
M10x60 Carriage Bolts (35), two Ø22xØ10x1.5t Washers (13), and two M10 Cap Nuts (65).
Tighten cap nuts with the Multi Hex Tool provided.
Hardware:
(13) Washer Ø22xØ10x1.5t
4 PCS
Multi Hex Tool
65 65
35 35
(35) Carriage Bolt M10x60
47 47
27 27
39 39
65 65
1 3
4 PCS
7
65 65
1 3
35 35
58 58
(65) Cap Nut M10
4 PCS