User Attendance Messages - Lexmark 7003-050 X340n Service Manual

7003-XXX

User attendance messages

Printer specific user attendance messages
Message
Change <source>
<type><size>
Check Tray x
Connection
Close Front Door
Load Manual
<type><size>
Load
Media<source><type>
<size>
31.xx Missing or
Defective Cart.
32.xx Unsupported
Print Cartridge
33.xx Chg Cart
Invalid Refill
2-10
Service Manual
Explanation
This message displays when none of the MFP input sources contain the size
and/or type of media requested by the current print job.
The following actions may be taken:
• Press , Start, or the 1 digit to clear the message and continue printing.
Note: Clearing the message this way will change the input source
size and type stored in NVRAM to the type specified in the prompt.
• Press the 2 digit. The MFP will process the job using the media currently
installed in the input device.
Tray x=Tray 2.
This messages displays for the following conditions:
• The specified device may have been removed from the MFP, possibly to
clear a paper jam or to uninstall the option.
• The option may be attached to the MFP, but a communications problem may
prevent the MFP from detecting the option. For example, there may be a
poor connection or a hardware failure.
• The following actions may be taken:
• If the option was temporarily removed or not connected properly, reattach or
reconnect it.
• Press Go to execute a configuration change which notifies the MFP the
option has been hot unplugged (removed with the power on).
Note: This action is not available if the MFP is in Diagnostics Mode or
running diagnostics.
• If the device is experiencing a hardware problem, turn the MFP off and on.
Close the front door. The message clears when the front door is closed. See
"Cover interlock switch service check" on page 2-22
displayed with the door closed.
The MFP has received a job that identifies the MPF as the input source.
The following actions may be taken:
• If paper is loaded in the MPF, press
• If paper isn't loaded in the MPF, load paper into the MPF.
The input source used by a job is empty.
The following actions may be taken:
• Load paper tray 1 or 2,and press
• Press Stop to cancel the job.
• The cartridge may be missing and the front door closed. Return the
cartridge.
• The cartridge may be defective. Replace the cartridge.
An unsupported toner cartridge is installed. A supported cartridge must be
installed.
Remove the toner cartridge, and install a new cartridge.
if this message is
or Start to begin printing.
or Start to resume printing.