Messages And Error Codes; Service Error Codes - Lexmark 7003-050 X340n Service Manual

Messages and error codes

Service error codes

Service error codes are generally non-recoverable except in an intermittent condition when you can POR the
MFP to temporarily recover from the error condition.
Service error codes (9xx)
Error Description
900 Service
RIP software
900 Service (No Modem)
902 General engine
software failure
914 DC Pick Motor
917 Transfer roll
920 Fuser Error
Indicates that the fuser
is below temperature
when printing.
921 Fuser Error
Indicates that the fuser
is below proper
temperature during
standby or idle time.
922 Fuser Error
Fuser failed to reach
standby temperature.
923 Fuser Error
Fuser is too hot during
printing or when MFP
is idle.
924 Fuser Error
An open circuit has
been detected in the
fuser thermistor circuit.
925 Fuser Error
Incorrect fuser lamp is
installed.
927 Fan Error
Fan is stalling.
Action
Server firmware problem. Turn off the MFP for one minute. If that does
not fix the problem, contact the next level of support.
The MFP did not detect the modem. See
page 2-26.
An unrecoverable engine software error. Reset the MFP (POR). If the
problem continues, replace the controller card.
A 902.33 error will occur if Tray 2 is set as the default, and Tray2 is
improperly, or not attached to the MFP.
Verify motor is plugged into controller card correctly. Also, check the load
condition.
Replace the drawer 2 assembly.
The most likely cause is a faulty HVPS. It may also indicate a problem in
the transfer roll area. Go to "Transfer roll service check" on
page 2-38.
Go to "Fuser service check" on page
Go to "Cold fuser service check" on page
Verify line voltage to the fuser. Go to
page 2-23.
Go to "Fuser service check" on page
Check cabling and connectors. Go to
page 2-23.
Replace fuser with the correct fuser. See
page 4-20.
Replace the fan. See "Fan removal" on page
manuals4u.com manuals4u.com
7003-XXX
"Modem service check" on
2-23.
2-20.
"Fuser service check" on
2-23.
"Fuser service check" on
"Fuser removal" on
4-18.
Diagnostic information
2-7