Exit Sensor Removal (On The Fuser) - Lexmark 7003-050 X340n Service Manual

Exit sensor removal (on the fuser)

1.
Remove the paper exit guide assembly. See
more information.
2.
Unplug the exit sensor at J10 on the controller card.
3.
Push the shaft (A) to the right using your right thumb against the inside gear surface and left index finger
against the opposite end of the shaft.
Warning: There will be some lubricant on the gear and shaft. Be sure to wipe hands clean with each
contact to prevent spreading lubricant to other areas.
4.
Align the two flats with the opening of the bearing support, and lift the right end of the shaft through the
support.
5.
Swing the shaft away from the MFP to expose the sensor flag.
"Paper exit guide assembly removal" on page 4-31
manuals4u.com manuals4u.com
7003-XXX
for
4-17
Repair information