Nvram Reset; Registration; Printer Registration - Lexmark 7003-050 X340n Service Manual

7003-XXX

NVRAM Reset

The NVRAM reset menu item is used to reset the network settings in the MFP's NVRAM.
To reset the NVRAM, perform the following tasks:
1.
In the Network Menu, scroll to NVRAM Reset.
2.
Press
The MFP will display Are you sure? Yes=1, No=2.
3.
Press 1, or 2 on the numeric keypad.
Pressing 1 will display resetting, and then return you to the Network Menu. Pressing 2 returns you to
the Network Menu item.

Registration

Printer Registration

Printer registration is performed to set the top, left ,and bottom margins of the MFP. The right margin is set
automatically when the left margin is set. Printer registration needs to be performed whenever the controller card
or printhead are replaced.
Note: Before setting the printer registration, ensure that the paper size selected in the Paper Setup menu
matches the paper size loaded in the tray.
Note: Always set the top and left margins first. This should be sufficient for proper registration of the printer.
The print registration range is:
Variable
s
B=
T=
L=
To set the printer registration, perform the following steps:
1.
Select REGISTRATION from the Diagnostics menu.
2.
Select PRINTER from REGISTRATION.
[Skew Page] displays.
3.
Press
The skew page prints out. The MFP exits diagnostics mode and returns to Ready.
The skew page contains the following information that can be used for setting the registration:
•
Firmware version. If the firmware version is prior to version XXXX, contact your second level of
support to obtain the latest version of firmware.
•
Paper size (A4 or Letter)
•
Top, left, right, and bottom margin settings.
4.
Perform steps 1 and 2.
5.
Scroll down to Top mrgn.
6.
Press
7.
Use Up and Down to adjust the margin.
8.
Press
3-6
Service Manual
to select NVRAM Reset.
Description Value
sign blank for positive values, "-" for negative values
Bottom margin -10 to +10—Each increment causes approximately 0.559 mm shift in the
bottom margin.
Top margin -16 to +16—Each increment causes approximately.169mm shift in the
top margin.
Left margin -16 to +16—Each increment causes approximately.339mm shift in the
left margin.
.
.
to save the margin setting.