Table of Contents
Advertisement
B.1
Handling Precautions
The optical characteristics are measured under stable conditions at 25°C (Room
Temperature)
1.
Since front polarizer is easily damaged, pay attention not to scratch it.
2.
Be sure to turn off power supply when inserting or disconnecting from input con-
nector.
3.
Wipe off water drop immediately. Long contact with water may cause discolor-
ation or spots.
4.
When the panel surface is soiled, wipe it with absorbent cotton or other soft
cloth.
5.
Since the panel is made of glass, it may break or crack if dropped or bumped on
hard surface.
6.
Since CMOS LSI is used in this module, take care of static electricity and insure
people are earthed when handling.
7.
Do not open or modify the Module Assembly.
8.
Do not press the reflector sheet at the back of the module to any directions.
9.
In case if a Module has to be put back into the packing container slot after once
it was taken out from the container, please press at the far end of the LED light
bar reflector edge softly. Otherwise the TFT Module may be damaged.
10.
At the insertion or removal of the Signal Interface Connector, be sure not to
rotate nor tilt the Interface Connector of the TFT Module.
11.
After installation of the TFT Module into an enclosure, do not twist nor bend the
TFT Module even momentary. At designing the enclosure, it should be taken
into consideration that no bending/twisting forces are applied to the TFT Module
from outside. Otherwise the TFT Module may be damaged.
12.
Small amount of materials having no flammability grade is used in the LCD
module. The LCD module should be supplied by power complied with require-
ments of Limited Power Source (IEC60950 or UL1950), or be applied exemp-
tion.
IDK-1119R User Manual
34
Advertisement
Table of Contents
