Advantech ETM-RES04C Touch Control Board is the ultimate combo board. This
touch panel controller provides optimum performance for your analog resistive touch
panels for 5 wire models. It communicates with the PC directly through USB and RS-
232 connectors. The touch panel driver emulates mouse left and right button func-
tions.
6.1
Touch Controller Characteristics
6.1.1
Specifications
Electrical Features
–
+5 Vdc/ 100 mA typical, 50mV peak to peak maximum ripple and noise.
–
Bi-directional RS-232 serial communication and USB 1.1 full speed
–
Report rate of RS-232 is 180 points/sec (max.). And, USB is 200 points/sec
(max.)
–
Unaffected by environmental EMI
–
Panel resistance of 5-wire resistive model is from 50 to 200 ohm (Pin to pin
on same layer)
–
Touch resistance under 3K ohm
Serial Interface
–
EIA 232E (Serial RS-232)
–
No parity, 8 data bits, 1 stop bit, 9600 baud (N, 8, 1, 9600)
–
Support Windows 2000/ Vista/ XP/ 7, Windows CE 5.0/ 6.0/ 7.0, Windows
NT4, Linux, DOS, QNX
USB Interface
–
Conforms to USB Revision 1.1 full speed.
–
If the USB is connected to the controller, the controller will communicate over
the USB, and will not communicate over the serial port.
–
Supports Windows 2000/ Vista/ XP/ 7, Windows CE 5.0/ 6.0/ 7.0, Linux, QNX
Touch Resolution
–
2,048 x 2,048 resolution
Response Time
–
Max. 20 ms
6.1.2
Environmental Features
Reliability
–
MTBF is 200,000 hours
Temperature Ranges
–
Operating : -25°C ~ 85°C
–
Storage : -25°C ~ 85°C
Relative Humidity
IDK-1119R User Manual
26