8-Bay Sff Hot-Plug Drive Cage Assembly - HP ProLiant DL180 Gen9 Service Manual

Lift and remove the access panel.
6.
To replace the component, reverse the removal procedure.

8-bay SFF hot-plug drive cage assembly

WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 26).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove all drives
3.
35).
Do one of the following:
4.
Extend the server from the rack (on page 26).
o
Remove the server from the rack (on page 29).
o
Remove the access panel
5.
Disconnect all cables from the drive backplane.
6.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
("Hot-plug drive" on page 36) and drive blanks
("Access panel" on page 37).
("Hot-plug drive blanks" on page
Removal and replacement procedures 38