RVCCH-75EC
U-CONNECT 8.4" SCREEN
(2-PIECE RADIO)
Chrysler
2011 - 2015 300
Dodge
2011 - 2015 Charger
2011 - 2015 Journey*
Notes:
*Dodge Journey requires different
camera (not included in kit), available
upon customer request.
Important Note: Not compatible in
vehicles with Manual Transmission.
IMPORTANT:
Compatible Radio Type:
U-CONNECT 8.4" SCREEN
REAR-VIEW INTEGRATION FOR CHRYSLER & DODGE VEHICLES 2011-2015 w/ 2-PIECE RA DIO
work. Following these instructions from "Start" to" Finish" will ensure a
smooth and hassle free installation.
822-1348. We are here to help.
PARTS INCLUDED:
(1) Universal Bullet Camera
(1) 15 ft. Extension
(1) CH-75E Interface
(2) CH-75E Harness
(1) Instruction
- Lens Angle 170 Degrees
- Resolution 420 TV Lines
- Min. Illumination 0.2Lux
- Voltage 12v
- Operating T
- NTSC
- Reference Lines
- Waterproof
PRECAUTIONS:
- Remove the negative side of the battery to avoid any short circuits
during the installation.
- Do not install the interface near any major components or near the
HVAC system. This may cause damage or overheating to the vehicle.
Please read the entire manual before installing this interface.
INSTALLING THE CAMERA AND INTERFACE
1. From inside the trunk, remove the third brake light from the trunk lid.
2. Drill a whole on the old brake light as shown on page two, then
route your power and video wiring towards the front. (See page 3)
3. Remove the factory radio to gain access to the factory
connectors. Connect behind the radio not behind the display.
5. Route the wires from the camera towards the radio and make the
power and video connections. For powering up the camera,
use the WHITE 12v output wire from the Can-Bus interface.
We recommend using the BLACK wire from the 8-Pin molex
connector. See below.
USING THE 8-PIN FOR GROUND
We recommend using the BLACK wire on the 8-Pin connector.
See picture below for where to tap.
TAP HERE/
BLACK WIRE
CONNECTIONS OVERVIEW
VIDEO HARNESS
22-PIN
WHITE
(male plug)
22-PIN
WHITE
(male plug)
TO FACTORY
DISPLAY
8-PIN
(male plug)
ON
1
2
3
4
5
6
STATUS LED'S
SETTING THE DIP SWITCHES
ON
1
2
3
4
5
6
Dip 1: Not Used.
Dip 2: Activates the Rear-View Camera image when the vehicle is in
reverse gear.
Dip 3: Not Used
Dip 4: Not Used
Dip 5 & 6: Varies, these switches are defaulted both to OFF.
If the radio is having turn-on issues please try the following:
Attempt T
F.
Attempt Thr
If none of the above solutions work out for your vehicle please
contact tech support.
LED STATUS:
RED LED
BLUE LED:
Pulsing = No BUS, Pending DATA
OFF = Complete Power Down
Solid = BUS Recognized
22-PIN
(female plug)
VIDEO-IN
(female plug)
22-PIN
(female plug)
TO FACTORY
HARNESS
WHITE/ 12V REVERSE OUTPUT
CAMERA POWER
TAP BLACK WIRE HERE
8-PIN CONNECTOR
MAKE SURE TO TEST THE CAMERA ANGLE BEFORE
RE-INSTALLING THE TAILGATE COVER.
PARKING LINE
The parking lines are there to assist you while reversing.
What the lines mean:
Yellow Line: CLEAR
Green Line: GETTING CLOSE
Red Line: WARNING - VERY CLOSE
YELLOW
GREEN
RED
Rev. 032015
GRAY
WHITE
VIDEO RCA
(SIGNAL FROM CAMERA)
*Camera not provided
TAP GROUND
ON BLACK WIRE OF
8-PIN CONNECTOR
CAMERA
INCLUDED
Need help?
Do you have a question about the RVCCH-75 and is the answer not in the manual?
Questions and answers