Table of Contents
Advertisement
<< FUNCTION >>
SAVE&END MENU1
HEX-DUMP V-ALMNT
USING THE
DIAGNOSTIC
FUNCTIONS
User's Manual
1. Enter setup mode.
Press the SETUP button until the printer beeps. Wait for the
printer to stop printing and check that the following
<<FUNCTION>> menu is printed:
MENU2
HARDWRE
ADJUST
INITIAL
2. Select the DEFAULT function.
Repeatedly press the "TEAR OFF" or "LOAD" button to
position the cursor on the left edge of the aluminum print guide
on DEFAULT. Press the button or the button to select the
DEFAULT function. The printer reprints the <<FUNCTION>>
menu. The default values in MENU1 and MENU2 are now reset.
3. Do either of the following:
See the section MENU1 and MENU2 Items and Options. To
exit setup mode and save the new defaults, make sure that the
cursor on the left edge of the aluminum print guide are
positioned on SAVE & END, then press the MICRO button
or the MICRO button.
This section describes how to use the following diagnostic functions:
SELF-TST
HEX-DUMP
V-ALMNT
These functions are used for checking print quality and diagnosing
printer problems. HEX-DUMP also provides useful information for
programmers.
Printing the Self-Test
The SELF-TST function prints test pages to check how the printer
operates independently of your computer. The self-test does not check
the interface between the computer and the printer.
The self-test prints the printer's firmware version, its resident emulations,
and all of the characters available in the currently selected character set.
If the DPL24C PLUS emulation is selected for MENU1, the self-test is
printed using the settings currently assigned to MENU1.
CONFIG
GAP-ADJ
Select new options for MENU1 or MENU2.
Exit setup mode, saving the factory defaults.
USING SETUP MODE
DEFAULT
LIST
SELF-TST
5-59
Advertisement
Table of Contents
