Install New Firmware On The Media Modules - Avaya G700 Installation And Upgrades

4
Installing a New G700 without an S8300
Install New Firmware on the G700 Media Gateway
Example: Show mg list_config

Install New Firmware on the Media Modules

For upgrades of active media modules, you need to take the media modules out of service before
initiating the upgrade process. To do this, go to a SAT session on the primary controller and issue a
busyout command.
Busyout board (for active media modules)
1
Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2
Verify the response, Command Successfully Completed.
3
Repeat for each media module to be upgraded.
Install media module firmware
1
Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on the
G700 motherboard) (see
does not occupy a physical position like other Media Modules.
2
At the P330-1(configure)# prompt, type
3
At the MG-001-1(super)# prompt, type
4
Type
where <slot #> is the slot of the specific media module as identified when you performed
Determine Which Firmware to Install on the
<filename mm> the full-path name of the media module firmware file in a format such
mm712v58.fdl, and
<tftp_server_ip_address> is the ip address of the S8300.
Two or three minutes will be required for most upgrades. The VoIP Media Module upgrade takes
approximately 5 minutes. Screen messages indicate when the transfer is complete.
196
SLOT TYPE CODE SUFFIX
---- ------ ----- ------
V0 G700 DAF1 A
V1 ICC S8300 A
V2 DCP MM712 A
V3 ANA MM711 A
V4 DS1 MM710 A
NOTE:
Skip this busyout procedure if the media modules are not in service; for example during an
initial installation.
Determine Which Firmware to Install on the
copy tftp mm-image v<slot #> <filename mm> <tftp_server_ip_address>
HW VINTAGE FW VINTAGE
---------- ----------
00 230(A)
72 00
2 58
2 57
1 58
.
session mgp
configure to change to the configuration mode.
G700,
Installation and Upgrades for G700 and S8300
VOIP FW
-------
67
N/A
N/A
N/A
N/A
G700). This VoIP module
December 2003