Install New Firmware On The G700 Media Gateway Processor - Avaya G700 Installation And Upgrades

1
At the P330-1(configure)# prompt, type
copy tftp SW_image <file> EW_archive <ew_file> <tftp_server_address> <Module#>
where
<file> is the full-path name for the image file with format and vintage number similar to
viisa3_8_2.exe,
<ew_file> is the full-path name for the embedded web application file with format similar to
p330Tweb.3.8.6.exe,
<tftp_server_ip_address> is the IP address of the TFTP server, and
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only one
G700 Media Gateway, the number is
2
To verify that the download was successful when the prompt returns:
— type
column for Bank B.
— type
EW_Archive file.
3
Type
reset <module #>
Install New Firmware on the G700 Media
Gateway Processor
Install MGP firmware
1
At the P330-1(configure)# prompt, type
processor.
2
Type
configure
the prompt to MG-???-1(configure)#.
3
At the MG-???-1(configure)# prompt, type
partition (bank) is in the Active Now column. You will update the bank that is not listed as Active
Now. The system displays the following screen:
Example: Show mgp bootimage
FLASH MEMORY
Bank A
Bank B
ACTIVE NOW
Bank B
4
At the MG-???-1(configure)# prompt, type
copy tftp mgp-image <bank> <filename> <tftp_server_ip_address>
to transfer the mgp image from the tftp server to the G700, where
<bank> is the bank that is not Active Now (Bank A in the example).
Installation and Upgrades for G700 and S8300
December 2003
1 .
show image version <module #>
dir <module #> and check the version number in the ver num column for the
at the MG-???-1(super)# prompt to enter configuration mode, which will change
IMAGE VERSION
109
210
ACTIVE AFTER REBOOT
Bank B
Installing a New G700 with an S8300
Install New Firmware on the G700
and check the version number in the Version
session mgp to reach the G700 Media Gateway
to determine which disk
show mgp bootimage
3
147