Log In Methods - Avaya G700 Installation And Upgrades

1
Roadmap and Reference
Connection and Login Methods
3
From the menu bar across the top, select Connection, then select New Connection.
The system displays the Connection Settings window.
4
Put in a name for the connection. Usually, this will be the name of your Media Server.
5
In the Host window, click Telnet.
6
Click the Emulation tab at the top.
The system displays the Emulation tab.
7
From the Emulator dragdown box, select the emulator you desire, usually 513BCT (default),
AT&T 4410, AT&T or DECVT100.
8
In the Keyboard window, select pbx.
9
Click the Modem tab.
The system displays the Modem tab.
10
In the IP address field, type the IP address of the connection's Dialup Status box as noted in
9 on
11
In the TCP/IP port number field, leave
5023 if you want to log in directly to the Communication Manager SAT command line.
12
In the Modem field, use the dragdown box to select the type of modem that your PC uses.
13
In the Serial port field, select the COM port you are using for your modem connection.
14
In the Baud rate field, select 9500 from the dragdown box.
15
Click the Dial Numbers tab.
The system displays the Display Numbers tab.
16
Type the phone number of the Media Server as appropriate. Enter 1 in the Country Code field for
long-distance.
17
Click OK.
18
On the Connections window, double-click. the name of the connection you just set up.
The PC dials up the Media Server, and when connected, the login prompt for the Communication
Manager software appears.
19
Log in to Communication Manager to access the SAT command prompt screen. If you are logging
in as craft, you log in to the S8300 Linux software. Then, see
ProductName SAT Screens

Log in Methods

This section describes how to log on to the S8300, S8500, or S8700 Media Servers using Telnet or the
built-in Web Interface and how to start a SAT session. These procedures assume:
•
You have a crossover cable directly connected from your laptop to the Services port on the media
server and your laptop is configured for a direct connection
•
Or, you are connected to the S8300, S8500, or S8700 Media Server over the customer's LAN,
either remotely or on site. In this case, your laptop must be configured to connect to the
customer's LAN and you would use the LAN IP address of the S8300 instead of 192.11.13.6.
The last procedure in this section describes logging in to the P330 stack processor when you have a direct
serial connection to the G700 Console port.
56
page 54.
on page 62.
if you want to log in at the Linux command line. Type
23
Open the Replace variable w/
Installation and Upgrades for G700 and S8300
Step
December 2003